Rather than leaving a 16-month gap between launching the two cameras as it did with the X-T1 and X-T10 though, Fujifilm has hardly missed a beat, announcing the X-T20 just over four months after the X-T2.
So should X-T2 owners now be kicking themselves over their purchase, or are there enough differences to separate the two?
- APS-C X-Trans CMOS III sensor, 24.3MP
- Touchscreen control
- High-resolution electronic viewfinder
Just as we’ve seen with the X-Pro2 and X-T2, the X-T20 incorporates Fujifilm’s latest 24.3MP X-Trans CMOS III APS-C sensor. It delivers a significant boost in resolution from the X-T10’s 16.3MP sensor, and brings the new camera in line with pretty much most of its competitors.
Sensor: 24.2MP APS-C CMOS
Lens mount: Fujifilm X-mount
Screen: 3.0-inch tilt-angle touchscreen, 1,040,000 dots
Burst shooting: 8fps
Autofocus: 325-point AF
Connectivity: Wi-Fi and Bluetooth
Battery life: 350 shots
The ISO range gets a boost as well, with a native sensitivity range of ISO200-12,800, compared to ISO200-6,400 on the X-T10, and while the expanded range stretches to the same sensitivity limits of ISO100-51,200, there’s some welcome news here too – unlike on the X-T10, where the expanded range was restricted to JPEG-only files, the X-T20 allows you to shoot raws as well JPEGs at this expanded range.
The X-T20 sticks with the same 2.36 million-dot OLED electronic viewfinder as we saw on the X-T10. Interestingly, while the resolution matches that of the EVF used in the X-T2, the magnification isn’t quite as impressive, at 0.62x compared to 0.77x, and not quite a match for the Lumix G80/G85’s 0.74x magnification.
While the X-T2 did away with a touchscreen interface at the rear – at the time Fujifilm believed, after feedback from users, that there wasn’t a demand for it – it seems to have had a bit of a change of heart for the X-T20.
The X-T20’s 3.0-inch touchscreen doesn’t quite offer the same breadth of control as, say, the one on the Canon EOS M5 or G80/G85 though, limiting you as it does to tapping the display to acquire focus and trigger the shutter, in addition to pinching to zoom when reviewing images; if you’re hoping to be able to toggle and adjust controls on the rear display you’ll be left disappointed.
Resolution receives a boost over the X-T10, increasing from 920k-dots to 1.04m-dots, matching that of the X-T2. Unlike the X-T2, the X-T20’s display doesn’t take advantage of Fuji’s double-jointed design, but the mechanism still allows you to pull the display outwards for waist-level shooting, and downwards should you want to use the camera raised aloft.
The X-T20 also comes equipped with Fujifilm’s X-Processor Pro imaging engine, which sees it spring into life a little quicker than the X-T10 at 0.4 seconds, while the shutter lag has been reduced to 0.05 seconds.
There’s just a single SD card slot on the X-T20, compared to the X-T2’s two, while it doesn’t support UHS-II cards.
The X-T20 offers 4K video capture (3840 x 2160) at 30p as well as Full HD (1920 x 1080) at 60p, both of which support film simulations as well. There’s an input for a microphone, but not for audio monitoring.